Home » Mustang News » Currently Reading:

NHTSA closes investigation for 2011-12 Mustang 6-speed transmission issues

December 21, 2011 Mustang News 2 Comments

mustang_transmission_six-speed

The Feds have closed the investigation pertaining to the 2011-12 Ford Mustang’s 6-speed manual transmission issues.  For those unaware of the  investigation, the NHTSA opened an investigation back in August after several 2011-12 Mustang owners reported problems with their 6-speed manual transmissions including cold shifting issues, sticky shifts, grinding gears and noise within the trans.  In total the NHTSA received 364 unique reports from various owners indicating shift quality issues.

The NHTSA’s official response was “There is no indication of loss of motive power or unreasonable safety risk associated with the alleged defect in the subject vehicles.”

The official report below addresses the issues and what Ford did to resolve them.

The Office of Defects Investigations (ODI) analyzed complaint data provided by Ford as well as complaints submitted to ODI from consumers.

Ford responded to the NHTSA’s investigation by identifying several factors that may contribute to the shifting issues including a cold transmission, clutch stay-out at high engine speeds, gear clash or grinding, and gradual loosening of clutch plate bolts in some early production vehicles.

The largest percentage of complaints indicated higher than expected shift efforts in cold ambient temperatures. These complaints were related to transmission fluid viscosity and the higher shift efforts resolved themselves with the drivetrain warming. Ford published technical service bulletin TSB 11-3-18 to inform technicians that a lower viscosity fluid was available for use to address the cold shift issues.

The clutch stay-out condition typically occurs at engine speeds greater than 4000 rpm.  It does not prevent the selection of any gear, but may delay clutch re-engagement depending on how long the driver maintains the higher engine speed. Ford identified rotating inertia of the clutch components as the root cause and replacement clutch pedal parts were made available under Ford TSB 10-19-4.

A number of reports alleged increasing difficulty selecting gears along with gear clash or grinding. Grinding or notchy gear shifts may be caused by gradual loosening of clutch plate fasteners, which is promoted by certain aggressive shifting. This condition is progressive in nature and initially results in symptoms related to shift quality/feel. Clutch plate bolt loosening will not result in inability to select any gear unless the progressive symptoms are ignored until complete clutch failure occurs.

ODI’s analysis identified only five complaints alleging an inability to shift into gear due to loose clutch plate bolts. None of these resulted in a stall and gear shifting could occur before engine start. A revised fastener was designed and implemented in production and is available for service through a special service message. There is no indication of loss of motive power or unreasonable safety risk associated with the alleged defect in the subject vehicles. This preliminary evaluation is closed.

Source: Ford and NHTSA




Currently there are "2 comments" on this Article:

  1. Tom P. says:

    Sad. Owners lose, but then again so does Ford. They just don’t realize it yet.

  2. darwin says:

    There were unique reports from various owners indicating shift quality issues. The National Highway Traffic Safety Administration has sealed its investigation into 29,807 2011-2012 standard transmission Ford Mustangs. The probe looked into grievances of shifting issues. The federal security regulators decided that a recall was not in order. Source for this article: Mustang drives away from NHTSA investigation

Comment on this Article:







Advertisement

Archives